Using Visio 2007 and for some reason, using dynamic connectors, I don't get line jumps. I've tried creating a new, basic drawing, select two dynamic connectors and cross them, no jumps. If I open a previous drawing that already has line jumps, and copy one of the connectors to the new drawing it won't show line jumps. If I paste that same connector again, then cross it against the first copied connector, it works. So something is preventing my new connectors from performing line jumps. I've checked the page layout settings and it all looks good. If I select the Behavior properties of a dynamic connector from the new drawing, I don't see the connectors tab. What in the world is going on??
Bill
