(Visio 2010, HP Wintel laptop) I've created a custom stencil that includes lines (connectors) with different kinds of arrowheads. I believe all the lines were defined using a Dynamic Connector as a basis. In the stencil, the master for each line is formatted with a 0.0625" rounded corner. When I drag the line from the stencil to the diagram, the new instance on the diagram always comes out with a square corner (Rounding = 0 in.) I tried deleting all the masters from the Document Stencil, but this had no effect. Why is this happening - what am I missing?
thx - Bill
